I ended sandblasting although my booger turned black.

I hang it all out and it is standby for painting.

I hang the center stand of Bandit 250 incidentally.

I mix paint and prepare a spray gun.
The paint is Kansai Paint’s RETAN PG Hybrid.
After having painted with 1 liquid, I paint clear.
Then, it is a specification that the curing agent permeates from above and it hardens completely.

The paint was hardened and it was not in a very good condition.
Rather than painting a surfacer, such exterior parts do not crack when the screw is tightened by using a soft curing agent for plastics with no undercoat, directly on the surface.

I paint.

I intended to give luster about the hub this time.But, a rough mesh of the sandblast was left.
I think that the cause is either because the paint was old, or whether the sand was too coarse and unevenness were added too much.

・Blow the surfacer once and blow after polishing it.
・Many times painting the top coat.
・Change sand of blast into fine one.
・Use the new paint.
I think that I have to take measures of it in such a thing.

The paint was old, but I was relieved because it cured safely.