Monthly Archives: January 2017

We do an unreasonable thing. We use milling cutter as a lathe adversely.

Old post share.
Diffusion welcome.

Although our company that is usually remodeling a motorcycle, we spend a technique seriously and make a duralumin cutting ballpoint pen.
The name of the ballpoint pen “is MechaSEA”.

An NC lathe is necessary to make a place to have of a ballpoint pen.
But, because there is not it in my company, I can not make it without outside order.
So I took the estimate and it was very expensive.
Therefore I decided that I made an NC lathe in-house.
Is it possible to produce in-house even my company with low production volume? As we thought about that, we do an unreasonable thing.
We use machining center as a lathe adversely.

I am very scared, chuck and bite are near !

And while producing the NC lathe in-house, it places an outside order by then if production increases.

This is the one that is completed. ↑
As for the most right thing, the chuck slipped and turned around.


Araki F Machine seriously introduced technology and made it.
It’s all made with cutting of the aluminum.
It’s extremely mechanical ballpoint pen, MechaSEA.
Tap the image or jump to the sales page by clicking.↓↓↓