{"id":786,"date":"2017-09-30T23:03:38","date_gmt":"2017-09-30T14:03:38","guid":{"rendered":"http:\/\/mechasea.com\/arakifunkeymachine-en\/?p=786"},"modified":"2017-12-19T00:24:05","modified_gmt":"2017-12-18T15:24:05","slug":"maintenance-of-equipment-inside-the-company","status":"publish","type":"post","link":"https:\/\/mechasea.com\/arakifunkeymachine-en\/?p=786","title":{"rendered":"Maintenance of equipment inside the company."},"content":{"rendered":"

Old post share.
\nDiffusion welcome.<\/p>\n

<\/p>\n

I used the zinc plating steel sheet.
\nIn case of attaching with TIG, it melts unless zinc plating is firmly peeled off.
\nThis time it is not the thing of the customers.
\nIt is used in my company.
\nSo, it melted a little as I imagined when I did it roughly.<\/p>\n

<\/p>\n

I was doing roughly, a gap was created between the pipe to be welded and the board.
\nI filled up the gap with wire.
\nBy the way, rust is not as much as zinc plating, but it gushes.
\nTherefore, copper plating is applied to the welding rod.
\nI should weld after rust is removed tightly.\u00a0This is commonplace.<\/p>\n

<\/p>\n

<\/p>\n

<\/p>\n

<\/p>\n

<\/p>\n

I used a rusting edge material.
\nSo I thought to paint in POR15 which was famous for paint to be able to paint with from the top of the rust.
\nBut, this paint has too strong adhesion, so it was impossible to open it for the second time and I gave it up.<\/p>\n

<\/p>\n

I decided to paint with used can spray.<\/p>\n