Buddhist vacation of one month ago, I was doing this.<\/p>\n
I changed the SR 500 to 17 inches in the past, but I feel comfortable in the corner and it is very good condition.
\nIt can tilt the motorcycle until rubbing a step.<\/p>\n
So, I bought rims and hubs before.<\/p>\n
The rim width of the front is 3.00.
\nIt can choose the color among gold, silver, black, four colors of the blue.<\/p>\n
<\/p>\n
I have SR 400 of type RH03J now. I will give its front around to a friend.
\nSo there is no wheel.
\nDuring the Buddhist holidays, I decided to assemble this 17 inch wheel.<\/p>\n
The hub buys used goods and I do sandblast and paint it.
\nSince the hubs after RH01J are common, it is circulating a lot.<\/p>\n
When the SR makes 17 inches because originally it is 18 inches, a spoke is too long.
\nSo I use spoke made in NEXXS, part number SPF-Y02.<\/p>\n
<\/p>\n
There are two kinds of spokes in the spoke set of NEXXS.
\nIt is in each bag written as outer and inner.
\nIt is different in length.<\/p>\n
But, it is not divided into an inner hole and an outer hole.
\nActually, it is the right and the left.
\nUse short spokes on the disk side and long spokes on the opposite side.<\/p>\n
You think that it looks faint in the photograph, but I mark it with magic so that they can distinguish at a glance.<\/p>\n
<\/p>\n
Front wheel temporarily tightens all spokes with twist tie and then put it on the rim.
\nThis is incorrect way of braiding, but temporarily holds all the spokes like this in this way.<\/p>\n
<\/p>\n
Finally, please temporarily fasten like this.
\nIt is cross beyond the four spokes.
\nAt that time, the outer hole is top.<\/p>\n
<\/p>\n
<\/p>\n
And I will take a shake off.<\/p>\n
If the runout is 1 mm or less, it is OK.
\nBecause a rim and a spoke are new, it is easy because it became less than approximately 1mm from the beginning.
\nI will tighten little by little while watching the runout until the spoke becomes good tension.<\/p>\n