<\/p>\n
I changed throttle to ACTIVE two pull.
\nThe master will change to radial of NISSIN.
\nSome wires became slightly remaining.
\nThough I bought 700mm, I look good even if another approximately 100mm is short.<\/p>\n
<\/p>\n
This air cleaner is not an article for exclusive use of the SR.
\nBut, when attaching a CR carburetor, since it is an ellipse, the surface area of the filter is large so that it is convenient.
\nThe manufacturer is K & N, the part number is RU – 2750.<\/p>\n
<\/p>\n
The adjust bolt of idling is convenient if I attach an extension wire.
\nIt seems to be called a remote idle adjuster.
\nIt is on sale from BITO R & D.<\/p>\n
<\/p>\n
The rear is attached without difficulty and the work is completed.
\nIt is cool when it is high grip!
\nWhen changing SR to 17 inches, superiority feeling is different.<\/p>\n
<\/p>\n
Today is up to here.<\/p>\n
<\/p>\n
Next time I will do the front.
\nBecause it is necessary to change the outside tube of the fork for an old thing, it takes time for a while.
\nI want to paint it in black.
\nI combine a caliper and a hub with used fork this time.
\nIt may be better in terms of certainty as it is newer to buy Y’sGear’s disk kit than searching for a used.
\nI can save labor. But,I have to buy a hub.<\/p>\n
<\/p>\n
Or make the original vehicle of the old age base as the base car.
\nBut, there is not SR500 when it is an advanced age type.<\/p>\n
Because I disassemble a fork, I bought a spring of HYPERPRO.
\nI want to take specifications to be able to turn at the corner comfortably.
\nBecause I am going to produce the second 17 inches, I think to paint the hub and this fork at the same time.<\/p>\n","protected":false},"excerpt":{"rendered":"
I changed throttle to ACTIVE two pull. The master will change to radial of NISSIN. Some wires became slightly remaining. Though I bought 700mm, I look good even if another approximately 100mm is short. This air cleaner is not an article for exclusive use of the SR. But, when attaching a CR carburetor, since it is an ellipse, the surface area of the filter is large so that it is convenient. The manufacturer is K & N, the part number is RU – 2750. The adjust bolt of idling is convenient if I attach an extension wire. It seems to be called a remote idle adjuster. It is on sale … Continue reading I change the SR 500 from 19 inches to 17 inches once again.<\/span>