I assembled a spoke and let I did getting out core and it was tubeless and did it and wear the tire.
\nBut, since I mistook the way to assemble the spokes, I will redo it.<\/p>\n
First of all, I tear off a tubeless kit.
\nWith the photograph, I warm it in heat gun.But, I noticed that I said that it was the same even if I didwarm not it even if I warmed it.<\/p>\n
<\/p>\n
Then I assembled it.
\nBut, it is a redo because it was long.<\/p>\n
<\/p>\n
I stopped the spoke with masking tape and put it in.<\/p>\n
<\/p>\n
And I noticed the mistake and disassembled.<\/p>\n
Next I stopped it with vinyl tie.<\/p>\n
<\/p>\n
This time it succeeded.<\/p>\n
<\/p>\n
Afterwards I let it make centering and stick a tubeless kit of OUTEX and wear a tire.
\nAnd complete it by attaching it to the car body.<\/p>\n","protected":false},"excerpt":{"rendered":"
I assembled a spoke and let I did getting out core and it was tubeless and did it and wear the tire. But, since I mistook the way to assemble the spokes, I will redo it. First of all, I tear off a tubeless kit. With the photograph, I warm it in heat gun.But, I noticed that I said that it was the same even if I didwarm not it even if I warmed it. Then I assembled it. But, it is a redo because it was long. I stopped the spoke with masking tape and put it in. And I noticed the mistake and disassembled. Next I stopped it … Continue reading Because I made a mistake in assembling 17 inch wheel spokes …<\/span>