The design of the dry clutch was completed a long time ago.However, it became clear later that a lot of jig for machining was necessary.
\nI am making it.
\nI plan to exhibit at the American Car Festa this weekend, but it may not be in time.
\nFirst I made a jig to hollow out the clutch cover.However, as the tip of the drill could not be cut off, the pilot hole of the M6 tap had gone wide.And the screw thread did not function.
\nSuch a thing is the first time.<\/p>\n
<\/p>\n
I bought helical coil wire screw thread insert in Benizen and made modifications.<\/p>\n
<\/p>\n
Helical coil wire screw thread insert is this.<\/p>\n
It cuts a tap with the same pitch but a large diameter and it is a thing put in a coil there.
\nIt is used when revive a failed screw thread or when stand screws on plastic.
\nIt took quite a while.<\/p>\n
<\/p>\n
Even at the professional ironwork, if dust enters the drill polishing machine and it gets polishes with eccentricity, it seems that such troubles may occur.
\nUntil now I was indifferent, but I understood that it is important to manage the eccentricity of the drill tip.
\nI get lost as to whether to buy a polishing machine.<\/p>\n
Also, when I was examining SR, I discovered two things that I was surprised.
\nThe SR has 500 and 400, but the parts are almost common.
\nSR400 is currently being produced, but the production of the SR 500 is over.
\nThe SR400 and SR 500 have the same cylinder diameter.
\nSo, it becomes 500 if I assemble 500 crank to 400.
\n400 and 500 pistons are slightly different, and a head is higher in 400.
\nSo if you assemble 500 cranks on 400 pistons you can make a high compression engine 500.It seems to be very fast.
\nWhen I check a price of the genuine crank of SR500, by several percent seem to rise year by year.It was a whopping 90090 yen.
\nBecause the crank of 400 is about 40000 yen, it is considerably high.
\nThe stroke up crank of the external goods is higher and it is about 140,000 yen.
\nThis is the first discovery.
\nThe second discovery is that it is cheaper to buy a 38 \u03c6 of the CR special than to overhaul a genuine CV carburettor.
\nBecause it costs 20,000-30,000 yen when I overhaul a pure carburetor, so you can pay 30,000 yen and buy a CR.
\nAnd I assemble 500 pistons in SR400 of FI and may be interesting even if I make low compression and attach a supercharger.<\/p>\n","protected":false},"excerpt":{"rendered":"
The design of the dry clutch was completed a long time ago.However, it became clear later that a lot of jig for machining was necessary. I am making it. I plan to exhibit at the American Car Festa this weekend, but it may not be in time. First I made a jig to hollow out the clutch cover.However, as the tip of the drill could not be cut off, the pilot hole of the M6 tap had gone wide.And the screw thread did not function. Such a thing is the first time. I bought helical coil wire screw thread insert in Benizen and made modifications. Helical coil wire screw thread … Continue reading SR400, 500 dry clutch and SR500 crank<\/span>