I dismantle a normal clutch and consider how I shall do it.
\nHow does it prevent oil from coming out?
\nThe place to put the oil seal is difficult.<\/p>\n
What should I do to attach it without processing to a main shaft?
\nEventually I feel like I have to make an offset clutch boss…<\/p>\n
How should I cut this long groove?
\nIf I make it with the equipment of my company, I will have to use a manual index table to cut one groove and turn it, cut one groove and turn it.
\nIn digging 27 grooves,it takes several hours.
\nI feel difficult if I do not use NC of 4 axes …<\/p>\n
<\/p>\n
<\/p>\n","protected":false},"excerpt":{"rendered":"
I dismantle a normal clutch and consider how I shall do it. How does it prevent oil from coming out? The place to put the oil seal is difficult. What should I do to attach it without processing to a main shaft? Eventually I feel like I have to make an offset clutch boss… How should I cut this long groove? If I make it with the equipment of my company, I will have to use a manual index table to cut one groove and turn it, cut one groove and turn it. In digging 27 grooves,it takes several hours. I feel difficult if I do not use NC of … Continue reading SR 400 dry clutch, quite formidable<\/span>