{"id":385,"date":"2015-06-11T23:45:14","date_gmt":"2015-06-11T14:45:14","guid":{"rendered":"http:\/\/mechasea.com\/arakifunkeymachine-en\/?p=385"},"modified":"2017-07-29T00:05:54","modified_gmt":"2017-07-28T15:05:54","slug":"bandit-250-engine-press-fitting-of-cylinder-sleeve","status":"publish","type":"post","link":"https:\/\/mechasea.com\/arakifunkeymachine-en\/?p=385","title":{"rendered":"Bandit 250 engine, press fitting of cylinder sleeve"},"content":{"rendered":"

This is the completed sleeve.<\/p>\n

<\/p>\n

I will put this in the cylinder block.<\/p>\n

I push all genuine sleeves with a hydraulic press and remove them from the block.<\/p>\n

<\/p>\n

I failed one and broke.<\/p>\n

<\/p>\n

<\/p>\n

I could somehow take.
\nThis is the block that removed the sleeve.<\/p>\n

<\/p>\n

The second cylinder from the left in this photo was scratched when pulling out.
\nSo I scraped off the part which swelled of the wound at Leutor.
\nThe cylinder which damaged the sleeve did not have any scratches.<\/p>\n

And I degreasing the sleeve and block which I made.Then I painted the sealant and press-fit.<\/p>\n

<\/p>\n

I put in with hydraulic press.<\/p>\n

<\/p>\n