I assembled it because the seal arrived.<\/p>\n
Just looking at the new inner tube holds expectation.<\/p>\n
<\/p>\n
The internal spring and color are carefully cleaned, are assembled.
\nIt is most safe to wash immediately before assembling.<\/p>\n
<\/p>\n
The viscosity of the fork oil blended 10 and 15 and had 12.5.
\nIt was okay to put only 15 and make it 15.But, I decided to use it because 10 oil remained.
\nThis is a picture before I throw away the weighing container.I use the measuring cup of paint made by MonotaRO.<\/p>\n
<\/p>\n
I overhaul the fork and also exchange stem bearings.<\/p>\n
<\/p>\n
<\/p>\n
<\/p>\n
It does not seem to be in a so bad condition.
\nThis is an outer race that I removed.<\/p>\n
<\/p>\n
There was a little line on the upper side.
\nThe stem is the condition that is bad for bearing.It is fixed at the same angle and receives vibration there.
\nIf it is rotating, the grease is repeatedly painted by the needle and cage, and the oil film is regenerated.But, when an angle is fixed, an oil film is cut, and metal comes into contact.
\nSurprisingly, metals are floating on the oil film.In a state called elastic lubrication or boundary lubrication.<\/p>\n
<\/p>\n
It seems to call it fretting wear.It seem to be able to restrain it by the choice of the grease.
\nIf I examine it, there is each maker various grease.
\nThe grease which the bearing maker sells is probably safe.So because they tested it.
\nThere was the maker which sold in 180 kg of units.I cannot use all it.<\/p>\n
I will exchange it for a new bearing.
\nI bought NSK’s HR32005XJ and HR32006XJ.
\nThis is not genuine parts are generic products.Because though it is the same thing, it is cheap.<\/p>\n
<\/p>\n
I restored it so far.<\/p>\n
<\/p>\n","protected":false},"excerpt":{"rendered":"
I assembled it because the seal arrived. Just looking at the new inner tube holds expectation. The internal spring and color are carefully cleaned, are assembled. It is most safe to wash immediately before assembling. The viscosity of the fork oil blended 10 and 15 and had 12.5. It was okay to put only 15 and make it 15.But, I decided to use it because 10 oil remained. This is a picture before I throw away the weighing container.I use the measuring cup of paint made by MonotaRO. I overhaul the fork and also exchange stem bearings. It does not seem to be in a so bad condition. This is … Continue reading Bandit 250, overhaul around the front<\/span>