This is the center stand of Bandit 250 painted with the SR hub before.
It became like this when I assembled it.
Because the spring was cheap, I made it a new one.
I paint a lot of chassis grease in the moving part and are assembling.

Originally it was rusted like this.

It was very cheap by the campaign before, so I bought it excess and was remained.It is a top case made in very big Coocase where two helmets are in.
(It is not good to purchase in excess.)

I will attach this to Bandit.

In Bandit there is a place which the person riding behind has when it is two-seater.
I will weld a carrier of Chaly there and make a carrier and attach a case there.

It’s a little big.

I cut it and shorten it.

It is just right size.

I twist the angle of the thicker pipe and weld it.

Chrome plating can be welded as it is without peeling off.

Let’s attach it like this.

I cut a too long place again.
And match it rub with a grinder and a belton to match the pipe.

I will peel off the paint of the place to weld.

And I will do spot welding.
After having done spot welding, if you are distorted hit it and fix it.

There was a load hook in the place that I cut.But, it penetrated in a pipe and was welded.
This is structurally strong.Besides, it will be attached by one shot by stud welding.The manufacturing cost is not so high.The genuine parts are really well thought out.

Spot welding Completed.

On the next time, it is completed by consecutive welding → sandblast → painting → case installation.

The next may become considerably earlier recently because work is jam-packed.
I have to proceed with custom of GAG as well.