SR400 dry clutch, work stopped for several years.
However, I got everyone’s encouragement comments, I was thought criticized in this ruler ↓.

So I advanced it.
I sew a clutch cover on jig and dig out the middle.

Because it was the program that I wrote very before, I processed it while feeling scared.

When I take a photograph, I can not photograph the inside unless I open half of the doors of the NC.So I open the door half and process it.
So, cutting oil splashes a lot here.
Though he did not notice because photographed, it was splashes to his foot a lot.
I moved to the position that was not dirty and watched him for a while.
And I thought about standing the box in front of the door of NC.

It securely prevented cutting oil.

However, when NC finally returned to the origin I had forgotten to remove the box.
I lost one box.

It became like this.
The next welds a block of the aluminum here.And process it with this machine again and make a place to enter the oil seal.

It is a dry clutch of SR 400 that will interrupt without mercy because it is not a job that is receiving requests from customers.
It seems likely to be able to resume because the installation of the truck container and the requested work has ended.
And it was quite a plus condition that chores were reduced as my employees increased by one so my burden was reduced.

Processing of small parts and obtaining of commercial products such as oil seal are quite done.So, if you open a large hole in the case and weld it, the prototype will be completed.

However, it works from the trial manufacture first properly and thinks that there is not the thing of the perfection.
So I think that I will be patiently repeating “remake each time I find a problem”.
I have made various things so far, but it is the first time for various people to say “I want it” goods before it is completed.
So I want to complete it early.